Maintenance of the hottest vulcanizer

2022-08-12
  • Detail

Maintenance and care of vulcanizing machine

the following problems should be paid attention to during the maintenance and care of vulcanizing machine:

1. Sulfur 1 crystal clear plastic rice products are loaded into the packaging bagging machine with the "golden we work" logo. The storage environment should be kept dry and well ventilated to avoid the humidity of electrical circuits due to humidity

2. Do not use the curing machine outdoors in rainy days to prevent water from entering the electric cabinet and heating plate

3. If the working environment is wet and watery, use things on the ground when disassembling and handling the vulcanizer. 6. You can output different reports according to the user's requirements. Do not let the vulcanizer come into direct contact with water

4. If water enters the heating plate due to improper operation during use, contact the manufacturer for maintenance first. If emergency repair is required, open the upper cover plate of the heating plate, pour out the water first, and then set the electric cabinet to manual operation, heat it to 100 ℃, keep the constant temperature for half an hour, dry the line, and glue the belt under manual state. At the same time, contact the manufacturer in time to replace the whole line. 5. If the curing press does not need to be used for a long time, the heating plate should be heated every half a month (the temperature is set at 100 ℃) and kept at the temperature for about half an hour

6. After each use, the water in the water pressure plate should be drained away, especially in winter. If the water cannot be drained away, it often leads to premature aging of the rubber of the water pressure plate. 5. Always keep the equipment clean and sanitary; The service life of the board is reduced

the correct way to drain water is to do it after the vulcanization and heat preservation is completed and before the vulcanizer is disassembled. If the water is discharged after the machine is disassembled, it may cause the water in the water pressure plate to not be completely discharged

Copyright © 2011 JIN SHI