Problems needing attention for the hottest aluminu

2022-08-03
  • Detail

Problems to be paid attention to for aluminum foil cap marks

I. composition design

1. during typesetting, square, triangle and waist cap marks must be more than 4mm outside the original, and pay attention to the position and distance between the marks. If the cap marks are arranged closely, there will be inaccurate cutting or punching die position

2. before plate making, it is necessary to understand the primary color of the cap mark, because there are many color samples on the cap at present. If the surface of the cap label is gold, it is necessary to pay attention to whether there is white in the part pattern that moves up and down to stretch and compact the experimental piece during the experiment, because the gold ink and white ink cannot be overprinted, and must be overprinted on the gold or white. It is best to design overprint during plate making, because overprint will increase the printing difficulty

3. pay attention to the proportion of front and rear tension in printing. Generally, the proportion of rear tension is higher than that of front tension. Generally, the rear tension is 10% higher than that of front tension. In the printing process, we should also pay attention to adjusting the angle of the scraper, which is conducive to extending the service life of the plate cylinder

II. Embossing

there are often problems of different embossing length and pattern depth during embossing. The main reasons are as follows: the inconsistent embossing length is usually due to poor printing winding and the front and rear tension of the embossing machine is not well controlled. The light pattern is mainly due to the unclean lanolin and the poor control of oil pressure. Wool in 2017, the production and sales of new energy vehicles in China are expected to exceed 700000. The unclean grease rollers are caused by the decolorization of the ink and can be cleaned with alcohol and propanol. If the pattern is too shallow, causing the aluminum foil to crack after embossing, you can press the aluminum foil cap mark with a few circles of paper, and then press the aluminum foil cap mark. In this way, the cap mark pattern will return to its original shape on March 1

III. flattening

flattening is the simplest process, but it should not be too thin during flattening. Generally, the flattening thickness of 1000 aluminum foil cap labels should be controlled within 5.5-6cm

in the production of aluminum foil cap labels, the above processes are done well, so there will be no great difficulty in cutting labels and stamping dies

the aluminum foil cap label is a good product only if it has no odor and strong tensile resistance. At present, most of the aluminum foils used in printing plants are "Bohai" aluminum foil and "Guangdong Meilun" ink

Copyright © 2011 JIN SHI